Toshiba g00c969 Service Note

BSI No.: G00C969 Publish
2000/03/23 Date: Subject: New Jig (Positioning Pin)
Model: FC22
Category Field Application UNIT
Correction of Service Manual
FactoryApplication: --
BSINo. G00C969 Page 1
Others Documents
CONTENT
To eliminate adjusting the magnification ratio of the lens when replacing the lens unit, the positioning pins have been supplied as a jig. The method used for this jig is shown below.
[Added Part No.]
MODEL P-I Addition Notes P I R FC-22 100-15
100-16
P-I: Page-Item P: Contents of Change I: Interchangeability R: Reasons for Change
[Method of Use]
Insert the positioning pins (front and rear) into the hole of the lens unit, and install to the scanner 1. unit. As the shape of the front and rear differs, pay attention to this point when installing parts.
------> A-F, A-R Fix the two oblong holes with two screws. (B: two points)2.
4406519390 JIG-PIN-LENS-F
A-F
4406519400 JIG-PIN-LENS-R
A-R
A B E -
A B E -
FAA
A-R
B
[Change of Service Manual] [Changed/Added Part No.]
Current Changed Contents
Service Manual
9. SCANNER
9.9 Disassembly and Replacement
[L] Lens unit Note: 3 After reinstalling the lens unit, the magnification ratio of the lens must be adjusted. (Refer to the Service Handbook.)
Service Handbook
1. ADJUSTMENT ITEMS
1.16 Adjusting the Scanner Section
1.16.2 Lens Unit
(b) Adjusting the magnification ratio of the lens
BSINo. G00C969 Page 2
A-F
B
Note 3. When reinstalling the lens unit, be sure to use the positioning pins.
(Refer to the Service Handbook.)
1. Deleted "(b) Adjusting the magnification ratio of the lens ".
2. Added "(C) Fixing the lens unit "
Content --- Refer to the above [Method of
Use].
Note: This subject has been corrected, on Mar. 23, 2000.
Attached File
Related Documents:
LinkTo: Link From:
Loading...