Toshiba f99f658 Service Note

BSI(Service Note) TOSHIBA

TOSHIBA TEC CORPORATION

2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN

BSI No

F99F658

SUBJECT

Change of Screw Hole for Installation

MODEL

CATEGORY

Other countermeasures

From June 1999 at the factory

CONTENT

There is a screw hole for a screw, the purpose of which is to prevent disconnection of the cable is
connected to MMF (FSMS) port.
As the screw-pitch of the cable is the inch type used on the market, the screw-pitch has been
changed accordingly to the inch type.

DP5570, DP6570

FIELD APPLICATION

To be applied when necessary

FACTORY APPLICATION

Date

99/06/15

UNIT

Electrical Circuit

DTM-F9504

Note

* If this change is made to unapplicable copiers and an inch type cable is used, the screw can not be
completely tightened. Therefore, the screw should be not tightened excessively and it is sufficient to
tighten its thread only.
* This part "P39-I.6 (4406382150 WH-SYS-MMF-300)" is fixed to the frame and has screw hole for
installation.

[Changed/Added Part No.]

P-I Before Change After Change Note P I R FAA
39-103 4843308930

JA-JFS-2.6S-C1N

P-I: Page-Item P: Content of Change I: Interchangeability R: Reason for Change

Screw to prevent disconnection

4843308931
JA-JFS-4S-C1N

C B J -

Meter -> Inch