Toshiba f99d587 Service Note

BSI(Service Note) TOSHIBA

TOSHIBA TEC CORPORATION

2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN

BSI No

F99D587

SUBJECT

Position Adjustment of ADU Holding Gate

MODEL

CATEGORY

Correction of Service Manual

CONTENT

An error in the explanation as well as omissions have been found in the "Service Handbook 1.15

Adjustment of ADU 1.15.2 Holding gate position adjustment". The correction is in this BSI.

1.15.2. Holding gate position adjustment

When the holding gate is removed for replacement, for example, the holding gate position must be adjusted when it is installed. (1) When installing the drive gears of the holding gate, match each of the drive gear positions with the positions of the dowels on the gear. Turn only the gear on the holding gate in the direction of the arrow by 2.5 (two (The front side gear need not be installed first, and the dimple on the rear side need not be aligned.)

DP5570, DP6570

FIELD APPLICATION

To be applied when necessary

FACTORY APPLICATION

<- error) teeth, and install the drive gears.

Date

UNIT

ADD/ADU

99/04/19

Drive gear

Holding gate

Note

(2) Next, align the projection on the clutch unit of the holding gate, and fasten by the E-ring.

-- Supplement of illustration --

Dowel

: wrong illustration in Manual

BSI No. F99D587 Page 2

E-ring

Clutch gate

Projection (convex portion) of clutch

(3) Check driving gear installation -- Addition of explanation -- Make sure that it is installed correctly according to the following points. If it not installed correctly, perform the (1)~(2) item points". * Open the clutch unit. (solenoid not pulled out) * Turn the gear in the figure in the direction "A" till the holding gate is stopped. * When the holding gate is stopped, check that B face and C face are roughly parallel. B face: flat face of holding gate C face: end face of frame

Clutch unit