Toshiba f99d584 Service Note

BSI(Service Note) TOSHIBA

TOSHIBA TEC CORPORATION

2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN

BSI No

F99D584

SUBJECT

Additional Parts when Installing the Paper Exit Tray

MODEL

CATEGORY

Other

-

CONTENT

To ensure perfomance of exiting-paper under all conditions, the parts used in the copier exit area for
the installation of the exit tray and the finisher differ as follows.

#.44 4402206980
RING-EXIT-24-UR
#.45 4401777720
COLLER-SFT-TRAY
#.112 7405006031
ERR060SKZN3A

DP5570, DP6570

FIELD APPLICATION

Others

FACTORY APPLICATION

Exit tray Finisher

2 pieces (needed)
2 pieces (needed)
2 pieces (needed)

Date

99/04/15

UNIT

Fuser/Paper-Exit

Not necessary

-

•@

[Installation Method]

1. Remove the lower exit cover (4 screws).

BSI No. F99D584 Page 2

Exit cover

2. Remove the rear E-ring, and slide the bearing
to the inside of the frame.

3. Slide the exit roller to the rear and the bearing
to the inside of the frame, and remove the exit
roller while pulling out the exit roller rear side.

E-ring

Exit roller

4. Install the exit roller groove 4402206980 RING-EXIT-24-UR (2 pieces) from the front side of the
exit roller.

Note

* The exit roller has the groove for installation.

Exit roller

4402206980
RING-EXIT-24-UR

5. Remove the following parts of
the rear side (refer to the figure on
the right).

* 1 pusher
* 2 gears

: : 1 E-ring

:2 screws

:1 E-ring