Toshiba f98d280 Service Note
BSI(Service Note) TOSHIBA
TOSHIBA TEC CORPORATION
2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN
BSI No
F98D280
SUBJECT
Change of PROM
MODEL
CATEGORY
To improve the reliability
From Apr. 1998
CONTENT
Error Content
l
l
MJ1003
FIELD APPLICATION
To be applied when necessary
FACTORY APPLICATION
After jam clearance, a mistake in detection caused a "finisher full" display to be shown.l
If a jam has occurred at the staple tray inside the finisher and the machine is restarted without l
removing the paper, CB1 (transport motor error) or CB2 (exit motor error) may take place.
After jam clearance, when copying is restarted, the paper can be stacked in the wrong trays.
Due change effected by the passage of time on the parts, it is possible that CB2 (exit motor l
error) may occur.
Finisher jams can occur in the central position stapling mode.
Date
UNIT
Finisher
98/05/13
DTM-F8308,DTM-F8408
Change of PROM
Correction of the above errors.
l
Change of the contorol : A change has been made to force the return to the home position (bin
l
1) if there is no further copying work within 30 seconds of the end of the last job.
Part Name
ROM 5-83
Label
Page-Item Before Change After Change Note Interchangeability
4402352150
PRA-780FIN-06
4F1-0560
1.2.3.4.5.6.
7.8.9.10.20.
4402352200
PRA-780FIN-16
4F1-0560
1.2.3.4.5.6.
7.8.9.10.20.
---- B
Loading...