Toshiba f97k088 Service Note

BSI(Service Note) TOSHIBA

TOSHIBA TEC CORPORATION

2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN

BSI No

F97K088

SUBJECT

Caution When Needed Installing the Key Copy Counter (KN-1550K)

Date

97/11/21

MODEL

CATEGORY

Treatment in the field

----

CONTENT

Regarding the caution needed when drilling a hole;
In BSI/F97I037 "New Copier 1560", the part in item 7, Installation of Key Counter" has been revised.
<BSI/97I037>: With regard to this kit installation, make a hole for a screw with a cutter or a thin

1560

FACTORY APPLICATION

driver. (a minus driver is better)

-----> :

Regarding the caution needed when drilling hole, do not use a cutter.

FIELD APPLICATION

To be applied when necessary

UNIT

Optional Kit

The hole should always be drilled with a minus driver.

When the hole is drilled, it is possible to do this from the front side with the cover still installed on the
copier. Though, if the place is difficult to find, remove the cover and open from the back side.