Toshiba f97e914 Service Note

BSI(Service Note) TOSHIBA

TOSHIBA TEC CORPORATION

2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN

BSI No

F97E914

SUBJECT

Change of the PROM

MODEL

CATEGORY

To improve the reliability

From May 1996

CONTENT

In order to increase the margin for detection of the present or absence of staples within the staple cartridge, the PROM has been changed as follows. (Adjustment value of staple-empty detection level has been changed 3.00V to 2.75V)

Adjust the level of the staple sensor as follows when the new PROM has been replaced.

MJ1002

FIELD APPLICATION

Others

FACTORY APPLICATION

Date

UNIT

Finisher

97/06/25

DTM-F6511

"Adjusting the Staple Sensor (PT1)"

1) Set an empty cartridge in the stapler unit.

2) Remove the rear cover, and turn SW1-2 on the controller ON.

3) Check that LED 1 on the finisher controller PCB is ON. * If LED 1 is not ON, turn VR1.

If flashes at long intervals

VR1

4) Pull out the empty cartridge from the staple unit, and set a cartridge with staples.

5) Check that LED 1 goes OFF. * If LED 1 fails to go OFF, check the face of PT-1 or staple cartridge for paper lint.

[ Change of part Number ]

Part Name

PROM

4408652720 PRA-735SRT-06

Current New

4408652890 PRA-735SRT-07

If flashes at short intervals

Interchangeability