Toshiba f97d877 Service Note

BSI No. F97D877 Page 1

BSI(Service Note) TOSHIBA

TOSHIBA TEC CORPORATION

2-4-1, Shibakoen, Minato-ku, TOKYO, 105-8524 JAPAN

BSI No

F97D877

SUBJECT

New Sorter MG-2014 (Service Manual)

Date

97/04/21

MODEL

CATEGORY

New Model Description

CONTENT

We are pleased to announce the availability of our newest sorter, the MG-2014.
The MG-2014 is very similar to the MG-2004 except for minor changes. Therefore, the Service
Manual is not specially prepared for this product, and this BSI in which the differences from the
MG-2004 are shown is to serve as a substitute.

[Differences from the MG-2004]

Items Contents

Power supply DC24V (The MG-2014 is powered by the copier through the

Control circuit This differs from that for the MG-2004.

MG2014

FACTORY APPLICATION

FIELD APPLICATION

Others

interface cable.)

UNIT

Documents

(Same as the MG-2010)

IPC board This differs from that for the MG-2004.

(Same as the MG-2011)
Control ROM only for the MG-2014
Sensors inside bin unit Adjusted automatically (Refer to data will be distributed

separately for details.)
Tandem There is no tandem function.
External cover Molded

[Contents]
Please use your Service Manual for the MG-2004 for all necessary technical information of the
MG-2014. However, refer to the Service Manual for the MG-2010 for the items listed below because
the control board for the 2014 is the same as the one as for the MG-2010.

BSI No. F97D877 Page 2

Pages of the Service Manuals for the MG-2004 and the MG-2010 corresponding to those for the
MG-2014

Service Manual for the MG-2004 Service Manual for the MG-2010

1. C. Controlling the Feed Motor (P. 2-22) P. 2-15

2. B. Stapler Unit (P. 2-32) P. 2-21

3. C. Controlling the Bin Shift Motor (P. 2-43) P. 2-31

4. D. Controlling the Guide Bar (P. 2-45) P. 2-33

5. E. Sensor Inside Bin Unit (P. 2-47) P. 2-35

6. VI. POWER SUPPLY (P. 2-51) P. 2-37

7. VII.SELF-DIAGNOSIS (P. 2-52 ~) P. 2-38 ~

8. VIII.TROUBLESHOOTING (P. 2-55 ~) P. 2-40 ~ 2-43

9. B. Variable Resistors, LED, and Check Pins by PCB (P. A-5) P. A-3

10. Using the DIP Switch (SW1) on the Sorter Controller PCB (P. A-6) P. A-4

11. General Circuit Diagram (Stapler Sorter) (P. A-8 ~) P. A-5