Magnia Rack Conversion Kit
Magnia Rack Conversion Kit
MAGNIA Rack Conversion Kit
Guide
MAGNIA 3030 / MAGNIA 3100 / MAGNIA 3200
TOSHIBA Europe GmbH 1
Magnia Rack Conversion Kit
Copyrights
©2001 TOSHIBA Europe GmbH. All Rights reserved.
Under the copyright laws, this document cannot be reproduced in any
form without the prior written permission of Toshiba. No patent liability is
assumed, however, with respect to the use of the information contained
herein.
Toshiba Magnia Rack Conversion Kit Guide
First Edition August 2000
Disclaimer
This guide has been validated and reviewed for accuracy.
The instructions and descriptions it contains are accurate for the Toshiba
Magnia Server at the time of the guide’s production. However,
succeeding computers and manuals are subject to change without notice.
Toshiba assumes no liability for damages incurred directly or indirectly
from errors, omissions or discrepancies between the computer and the
guide.
2 TOSHIBA Europe GmbH
Magnia Rack Conversion Kit
Contents
Section 1.1.0 Converting the Magnia to Rack Model.................4
Section 1.2.0 Magnia 19” Rack Model.........................................6
Rack Installation ........................................................................6
Using a Lift to Install the server into a Rack ..............................7
Attaching the Front Panel ..........................................................9
Removing the Server from a Rack Enclosure ..........................12
Installing the Server into a Rack Enclosure..............................14
TOSHIBA Europe GmbH 3
Magnia Rack Conversion Kit
1.1.0 Converting the Magnia to Rack Model
To install the Magnia tower model in the rack, the server must be
converted into a rack-model.
To convert the server from a tower to a rack-model, follow the steps
below and refer to Figures 1-48 to 1-50.
1. If the server is in operation, shut it down. Once the server has been
shut down, then switch the AC knob on the back of the server to OFF
and unplug the AC power cable.
2. Open the front door and lift the door off the hinges.
Remove the 4 runner feet.
Figure 1-48 Removing the front door and 4 rubber feet
3. Remove 5 screws, top panel and lock key as described below.
4 TOSHIBA Europe GmbH
Magnia Rack Conversion Kit
Top panel
Lock key
Figure 1-49 Removing the top panel and lock key
To install the front panel for rack mounting, attach the two panel brackets
with 9 screws.
TOSHIBA Europe GmbH 5