Toshiba 1400RB, 1400TB User Manual

Colour

Welcome to the bright new world of Toshiba colour. Your new precision built colour television has been designed and engineered largest manufacturer's of

by one of the world's

I.C.'s, transistors and diodes to give you an extremely reliable and natural performance. Please read this manual and retain for future reference.

The mains supply required for this equipment is 220v to 240v 50Hz. Never connect to a DC supply or any other power source. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approval extension lead or consult your dealer. If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. If this product is not provided with a mains plug, or one has to be fitted, then follow

instructions given below:

,iPORTANT.

marked with the letter E or by the safety earth symbol or green-and-yellow. The wires in the mains lead on this product are coloured in accordance with the following code:

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is

marked with the letter

When replacing the fuse only a correctly rated approved type should be used and

be sure to re-fit the fuse cover. IF IN DOUBT

Carefully release back cover catch or slide back cover and remove

battery cover, insert 2 batteries, taking care to observe correct

polarities.

DO NOT make any connection to the larger terminal which is

BLUE: NEUTRAL BROWN:

or coloured red.

CONSULT A COMPETENT ELECTRICIAN.

or coloured green

LIVE

Choose a position where direct light from a lamp or window does not fall on the screen. Wherever possible out of the reach of young children. Make sure that there is adequate air circulation through the vents

on the rear cover of.the receiver. Do not place the receiver close

to curtains or in an enclosed space.

Optimum reception of colour and teletext requires a good signal and will generally mean that a loft or outdoor aerial must be used. The exact type and siting will depend upon your particular area and your local aerial installers will be best to advise. Where signals permit, a set top aerial may be used by plugging into the aerial socket and rotating to obtain the best picture.

Suitable battery types are: R03 or

AAA

or SUM-4 (1400RB).

or SUM-3 (1400TB).

Tuning

Connect your aerial to the socket at the rear of the set anc insert the mains plug into a mains socket.

Press the mains switch button and a red light will glow. If picture does not appear after several seconds, press th~ button 0 on the remote control, or any of the four "power on' buttons on the front of the receiver.

3a. To Tune in all Channels Automatically

i. Press CH

buttons on the remote control until programme position 1 is selected.

Press the

ii.

the letters ASM is present, press either the adjacent + or - buttons. The set will now search through the complete frequency range in ascending order.

3b. To Tune into any desired programme position

Press CH buttons on the remote control to select required programme position.

ii.

Press the the symbol symbol is present, press either adjacent set will begin to search and will stop at the first signal encountered. If this is not a wanted signal, while the symbol

>>>

is present press adjacent + or - buttons. If the symbc' is seen to slowly pulse, the search has reached a band and may be restarted by pressing + or

iii.

Repeat sections 3b i, and ii, until all channels are memorised.

iv. Fine tuning may be achieved by repeatedly pressing the

[17

button on the hand held unit until the appears in screen area A, and whilst this display is present,

buttons on the receiver or POS

[77

button on the remote control repeatedly until

amear in screen area

buttons on the receiver or POS

[77

button on the hand held unit repeatedly until

>>>

appears in screen area A and while this

Theil while this dis~lav

39)

or - button. The

symbol

enc

To adjust colour

Press button

repeatedly until the appropriate function symbol appears on the screen.

Adjust level by ,means of adjacent + or - buttons.

To adjust Volume Press

held unit to select required level. Function and level setting will be displayed.

Note: This set has an automatic "No signal switch-off" facility, and will switch itself off, if the following procedure is applied:

Press the four buttons CH receiver simultaneously, the word ON or OFF will be displayed on screen. If the word OFF is displayed, then this facility will not operate, however if ON is approximately Selection between the word ON and OFF is possible by repeatedly pressing the four CH

the set.

contrast

(

(=)

and brightness

)

on the hand held unit

buttons on the front of the receiver or on the hanm

and

on the front of the

displayed, then the set will turn itself off

minutes after the transmitter closes down.

andA

buttons on the front of

+ 4 hidden pages