Toshiba 1000 Series Installation Instructions Manual

FOR AUTHORIZED SERVICE PERSONAL ONLY

TOSHIBA/HOUSTON INVERTER PLANT
DESIGN DATA D-UM0029 Page 1 of 4
SUBJECT:

1000 Series UPS Options – Frequency Conversion

Models: 1000 Series UPS

CAUTIONS

&

INSTALLATION INSTRUCTIONS

Cautions:

Any maintenance, additions, and/or changes that are to be done to this UPS should be
performed by a certified Toshiba trained repair technician authorized to service
Toshiba’s 1000 Series UPS.

The followings are a list of minimum safety requirements that should be adhered to,
and is not to be interpreted to be the only safety requirements to follow. Please follow
all Local, State, and Federal Safety Requirements.

1) Verify that the UPS is off and that the power cord or main power is disconnected from

the power source. (Observe Lock-out/Tag-out procedures if applicable)

2) Remove watches, rings, and/or other metal objects.

3) Use insulated tools to prevent inadvertent shorts.

4) Wear safety glasses, rubber gloves and boots.

5) Do not lay tools or metal parts on top of the batteries.

6) All connections must be made in accordance with National and Local Electric Codes.

In no event will Toshiba Corporation be responsible or liable for either indirect or
consequential damage or injury that may result from the modification of this unit.

Installation Instructions:

RELATED DATA FILE NO.

COPY DRAWN BY: DATE:
TO: H. Huynh 10/2005
TO: CHECKED BY:
TO: MTA 10/2005
TO: APPROVED BY: DATE:

NO. REVISION DATE BY TO:

FOR AUTHORIZED SERVICE PERSONAL ONLY

TOSHIBA/HOUSTON INVERTER PLANT
DESIGN DATA D-UM0029 Page 2 of 4
SUBJECT:

Install “FlashH08” Flash Program

There are two types of installation files for the Flash program. The one that is appropriate
for you can be determined by first checking the “CPU Version” that is displayed on the
LCD display in the front panel.

1.) If the format is XX.X
This means that the CPU is an R mask type. In this case you should run the

“Flash3062_R” program to install the “FlashH08” flash software. Further instructions on
configuration are explained below.

2) If the format is XX.XB
This means that the CPU is a B mask type. In this case you should run the “Flash3062_B”

program to install the “FlashH08” flash software. Further instructions on configuration are
explained below.

Use “FlashH08 ” to flash R mask type/B mask type CPU

1. To properly configure and utilize this software, terminate all applications that

occupy COM 1. (COM 1 is the default communication port for this software)

2. Connect the RS232 cable to the UPS from “COM1” of the PC.

3. Turn off the UPS, but keep the AC Line on. The proper procedure for this is

explained in the UPS manual that is included with the UPS.

4. Click on the appropriate “FlashH08” software that was installed in the previous

section.
i. If you installed the R mask type, it should be labeled “R Mask Flash” in the

1000 Series UPS Options - Frequency Conversion

title like the one shown below.

NO. REVISION DATE BY