Toro TR70XT SERIES Instruction Manual
360
TR70XT
SERIES ROTOR
Align the cap arrow with the left side
of the watering area. This is the nonadjustable side of the watering arc.
Watering Arc Adjustment
Turn the arc adjustment ring to align
the right stop arrow to the right side
of the watering arc.
The watering area is between the cap arrow and the right stop
arrow on the arc adjustment ring. This example is set to 180°.
Align the right stop arrow to the right
side of the watering arc.
The watering area can be adjusted between 30° and 360°.
When set to 360°, the nozzle does not reverse direction.
Instruction Guide
Right Stop Arrow
The nozzle trajectory angle can be adjusted between 5° and 25°.
Insert the blade end of the sprinkler tool or a screwdriver through
the cap. Turn the adjustment screw right to decrease the angle
and shorten spray radius, or left to increase the angle and lengthen spray radius.
Nozzle Trajectory Adjustment
Español
English
Français Deutsch
Italiano
português
© 2004 The Toro Company, Irrigation Division • An ISO 9000-certified Company • www.toro.com Form Number 373-0289 Rev. B
The TR70XT sprinkler comes with
seven additional nozzle sizes from
7 to 27 GPM (31.8 to 122.7 LPM).
To change the nozzle, insert the
blade end of the sprinkler tool or a
screwdriver through the cap. Turn
the nozzle screw out until it clears
the nozzle. Pry the nozzle out at the
bottom and install the new nozzle.
Return the nozzle screw to its
previous position.
Turn the nozzle screw in to diffuse and
shorten the spray radius.
Turn the center screw right to shut
off flow. Turn the screw left to open
flow.
To eliminate check valve
function, install the check
valve disk in position B.
Remove and
flush screen
as needed.
Changing Nozzle
Adjusting Spray
Cleaning Screen
Check Valve
Flow Shut Off
To maintain left
stop, align riser
with body as
shown when
reassembling.
102-1303
102-2633
Loading...