Toro H132, 70185, G132, 70186 Setup Instructions

G132 and H132

Rear Engine Riding Mowers

Model Nos. 70185 and 70186

Loose Parts

Description Qty. Use

Form No. 3353-221

Setup Instructions

Wheels

Flat washers, M16 (3 mm thick)

Spacers, M16 (1 mm thick)

Cotter pins

Seat

Screws, M8 x 18 mm

Flat washers, M9

Lock washers

Socket pin 1 Attaching the steering wheel

Engine cover

Screws, M6 x 25 mm

Frame

Fabric bag with clips

Handle

Locknuts, M8

Washers, M9

Z-brackets

Bolts, M6 x 16.2 mm

Nuts, M6

Grass collector cover

Pins

Full bag lever

2

2

Installing the front wheels

4

2

1

4

Installing the seat

4

4

1

Installing the engine cover

2

1

1

Assembling the grass collector

1

2

4

2

2

2

Installing the grass collector

1

2

1

Bolts, M6 x 20 mm

Flat washers, M6.5

Nuts, M6

Recycler® cover 1

Draining tube 1 Draining the engine oil

Keys 2 Using the keys in ignition and KeyChoice® switches

Spark plug wrench 1 Replacing the spark plug

Operator’s Manuals (English and French)

Engine operator’s manual

W 2004 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196

2

4

Installing the battery

2

Recycling the grass clippings; refer to the tractor

Operator’s Manual

2

Reading before operating the tractor

1

Contact us at www.Toro.com

1

All Rights Reserved

Printed in Italy

Assembling the Tractor

Installing the Front Wheels

1. Slide a flat washer (M16, 3mm thick) onto each spindle
(Fig. 1).

Attaching the Steering Wheel

1. Rotate the steering wheel upward until it is aligned with
the steering column.

2. Secure the steering wheel with the socket pin (Fig. 3).

4

5

1

3

2

Figure 1

1. Spindle

2. Wheel

3. Flat washer
(M16, 3 mm thick)

4. Spacers
(M16, 1 mm thick)

5. Cotter pin

2. Mount the wheels and secure each of them with
2 spacers (M16, 1 mm thick) and a cotter pin (Fig. 1).

3. Grease the wheels.

Installing the Seat

Attach the seat to the support plate with 4 flat washers
(M9), lock washers, and screws (M8 x 18 mm) (Fig. 2).

1

1

Figure 3

1. Socket pin

Installing the Engine Cover

1. Slide the tabs on the engine cover into the slots on the
body of the tractor (Fig. 4).

2

Figure 2

1. Seat Support plate

2. Flat washer (M9)

3. Lock washer

4. Screw (M8 x 18 mm)

Note: Before tightening the screws, adjust the seat to a
position that is most comfortable for you.

1

2

3

4

m–5980

Figure 4

1. Engine cover 2. Screw

2. Secure the cover with 2 screws (M6 x 25 mm) (Fig. 4).

2