Toro 99-8923 Installation Instructions
FORM NO. 3322-694
Oil Drain Valve Kit
Part No. 99–8923
Loose
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
O–Ring
Oil Drain V
Installing
1. Locate and remove existing oil drain plug.
2. Install O–Ring onto oil drain valve (Fig. 1).
Parts
alve
Oil Drain V
Note: Install this kit when changing oil.
alve
1
1
Install Oil Drain V
1
alve
2
INSTALLATION
INSTRUCTIONS
3. Backout clamping nut out until it touches drain
outlet (Fig.1).
4. Install oil drain valve into engine block. Install
the drain outlet facing down. (Fig. 2).
5. Tighten clamping nut and torque to
approximately 85–90 in–lbs (9.6–10.2 Nm)
(Fig. 1).
2
1
5
3
1. O–Ring
2. Clamping
3.
Oil Drain V
Printed in USA
Nut
alve
Figure 1
4.
Drain Outlet
5. V
alve end
4
m–4404
The T
oro Company – 1999
All Rights Reserved
1. Oil
O–Ring
Drain V
Figure
alve with
2
2.
Engine Block
IMPORTANT: Remember to fill engine with
oil after oil drain valve is installed.
Operating
Oil Drain V
alve
1. Use either a flat screw driver, 3/8” wrench or
10mm wrench to open and close valve.
2. Rotate valve end clockwise to close valve.
Rotate valve end counterclockwise to open
valve.
m–4403
Loading...