Toro 99-2532 Installation Instructions
FORM NO. 3321–467
PINION GEAR KIT
FOR SIDE DISCHARGE WALK POWER MOWERS
Loose Parts
Note: Use the chart below to identify parts
used for assembly.
DESCRIPTION QTY.
Gear 1
Washer 2
Before Installing
PART NO. 99–2532
Removal
1. Remove wheel bolt and wheel (Fig. 1). Retain
for reassembly.
INSTALLATION
INSTRUCTIONS
3 45
2
1
POTENTIAL HAZARD
• If you leave the wire on the spark plug,
someone could accidentally start the engine.
WHAT CAN HAPPEN
• Accidental starting of engine could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
• Pull wire off spark plug before you install
kit. Also push wire aside so it does not
accidentally contact spark plug.
1. Disconnect spark plug wire from spark plug.
Printed in USA
The Toro Company – 1998
1. Wheel bolt
2. Wheel
3. Pin
2. Raise front drive axle and support it with wheels
3. Rotate height-of-cut adjusters 180 until the
4. Place a 2”x4” wood block under pinion gear.
All Rights Reserved
m–xxxx
Figure 1
4. Pinion gear
5. Washer
off ground.
knobs point straight down to the ground.
Using a hammer and punch, drive pin out of
pinion gear. Retain pin for reinstallation.
Installation
5. Remove pinion gear and washer (Fig. 1).
Discard these items.
Assembly
1. Install (2) new washers and pinion gear provided
in kit (Fig. 2).
2. Place a 2”x4” wood block under pinion gear and
drive pin in with a hammer.
3. Reinstall wheel and wheel bolt (Fig. 2).
3
1
2
1. Washer (2)
2. Pinion gear
3. Pin
4
5
m–xxxx
Figure 2
4. Wheel
5. Wheel bolt
2
Loading...