Toro 99-0268 Installation Instructions
ROLLER KIT
for OFZ 48” MOWER
FORM NO. 3321-472
PART NO. 99-0268
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
Roller bracket
Bolt 3/8-16 x 3/4” (19 mm)
Locknut 3/8–16
Roller
Bolt 1/2-13 x 4” (101 mm)
Nut 1/2-13
Parts Catalog 1 Save for ordering parts
2
8
8
Install rear rollers
2
2
2
Mower Preparation
INSTALLATION
INSTRUCTIONS
For ease of performing these modifications remove
mower from traction unit; refer to Mower Operator’s
Manual for instructions.
Install Rollers
Adjusting Rollers
1. Remove locknut, bolt and roller from mounting
bracket.
2. Clamp roller bracket against rear of mower, next
to side of discharge opening and flush with the
bottom of the mower (Fig. 1).
3. Using bracket as a guide, center punch, pilot
drill, then drill drill (4) 13/32” (10.5 mm) holes
in the mower (Fig. 1).
4. Insert (4) 3/8–16 x 1” (26 mm) bolts through
from inside mower and secure with (4) 3/8-16
locknuts (Fig. 1).
5. Repeat on opposite side for other roller bracket.
6. Select the proper hole position for roller,
depending on height-of-cut to be used; refer to
Adjusting Rollers.
2
The rollers must be changed for heights-of-cut.
Above 2” (51 mm) the rollers must be adjusted to the
lower hole location. If the height-of-cut is set to the
1” or 1–1/2” (25 or 39 mm) the rollers must be
adjusted to the upper hole location.
1. After adjusting height-of-cut, tilt mower to
adjust front roller, refer to; Tilting Mower.
2. Remove the locknut and bolt to change hole
location (Fig. 2).
3. Select the proper hole position for the
height-of-cut to be used (Fig. 2).
4. Insert 1/2-13 x 4” (101 mm) bolt through roller
and secure with 1/2-13 locknut (Fig. 2).
5. Lower mower, refer to; Tilting Mower, then
repeat adjustment on rear rollers.
3
1
2
4
1. Roller bracket
2. Center punch, pilot drill,
then drill (4) 13/32”
(10.5 mm) holes
Figure 1
1
m–4002
3. Bolt 3/8-16 x 1” (26 mm)
4. Locknut 3/8-16
3
1
5
3
3
1
1. Roller
2. Bolt 1/2-13 x 4” (101 mm)
3. Locknut 1/2-13
4
Figure 2
2
4. Spacer
5. Holes
5
2
m–3940
2