Toro 99-0263 Addendum

FORM NO. 3321-712

PLENUM KIT

for OFZ Grass Collector

MODEL NO. 99-0263

Note: Replace page 2 of you Installation Instructions with the following page.

Hinge bracket
Screw 10–24 x 1/2” (13 mm)
Locknut 10–24

Locking pin 3/8 x 6” (152 mm)
Spring–short

Parts Catalog 1 Save for ordering parts

Unit Preparation

1
2
2

1
1

Install hinge bracket

Install chute

2

Install Spring and Guard Brackets

INSTALLATION

ADDENDUM

3
9
8

1 Remove the existing spring and spring bracket

from below the traction unit control plate
(Fig. 1). Save the spring bracket for use on the
chute. Discard spring–long.

2 Attach the new, long spring bracket below the

traction unit control plate with the existing bolt
in the front left hole, down from the top, and
secure it with the existing locknut (Fig. 1). Hook
the short chute spring into the bracket.

3 Remove the existing hardware from the left

brake bracket below the traction unit control
plate (Fig. 1).

4 Attach the guard, below the brake bracket, with a

new 3/8–16 x 1-1/4” (32 mm) bolt in the front
hole. Include the cable and secure with the
existing washer and locknut above the control
plate. Use the existing rear bolt and locknut
(Fig. 1).

1

4

1 Spring bracket–long
2 Existing bolt
3 Existing locknut
4 Spring–short
5 Brake bracket

3

Figure 1

5
6

7



6 Guard bracket
7 Bolt 3/8-16 x 1-1/4”

(32 mm)
8 Cable
9 Existing washer

2