Toro 95-7858 Installation Instructions
Side Light Kit
FORM NO. 3319–589
PART NO. 95–7858
Loose Parts
DESCRIPTION QTY. USE
Side Light Bulb 2
Side Light Socket and Wire Assembly 2
Installing Side Lights
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“STOP” to stop the engine. Remove the key.
2. Push the hood latch (Fig. 1), located just above
the indicator light panel, to the left.
3. Raise the hood to full height.
Kit installation
4. Pull the head light wires off the head light
terminals.
5. Remove the reflective tape covering the side
light opening on the reflector ( Fig. 2).
1
INSTALLATION
INSTRUCTIONS
2
1. Hood latch
Printed in USA
Figure 1
m–3366
Figure 2
1. Side Light 2. Side Light Opening
6. Push the side light into the openings so that the
1
m–3314
tabs on the lights go into the notches in the
opening (Fig. 2). Turn each light a quarter turn
clockwise to lock it in place.
The Toro Company – 1997
All Rights Reserved
Installation
7. Connect the orange side light wire to the head
light terminal where the orange head light wire
was connected (Fig. 3).
4
5
6
6
3
2
5
1
m–3367
Figure 3
1. Orange Si d e L i g h t W i r e
2. Orange Head Light Wire
3. Black Side Light Wire
4. Black Head Light Wire
5. Tab
6. Head Light Terminal
8. Connect the black side light wire to the head
light terminal where the black head light wire
was connected (Fig. 3).
9. Connect the orange head light wire to the tabs on
the orange side light wire (Fig. 3).
10. Connect the black head light wire to the tabs on
the black side light wire (Fig. 3).
11. Repeat steps 4 through 10 to install the other
side light.
12. Close the hood.
2
Loading...