Toro 95-6950 Installation Instructions

Remove the upper grip, lower grip, height of cut

at the gearbox lever and

Install kook and clutch spring with new washer (

Check the matching points, cable retainer / belt

Install clutch

Matching points must

Cable hook to

Note: If there are 2

Free end of the

Part-No: 95

6972

Hook

Part -No: 95

6976

Part-No:95

6971

Form No. 95-6977

AutoMatic Drive System Update Kit

Fits Model 21014 - 210000101 to 240999999

Modifications at the gear box

1. Remove belt cover (fig.1).

2. trigger, shield cover (Fig 1).

3. Unhook the drive cable the cable retainer (Fig. 2).

4. Remove the clutch spring (Fig. 2).

5. Fig. 2 and 3)

6. Install new drive cable to the clutch lever (Fig. 4).

7. guide if the gearbox is pushed back by hand (Fig.4). If the points do not match, please correct by shifting the cable retainer back or forward.

8. Install shield cover. (Fig.1). The lower grip and the belt cover will be installed lastly.

Instruction

Model No. 95-6950

Fig.1

spring incl. hook and washer

Fig. 3

hook must point down

Fig.2

stay face to face when the gearbox is pushed back

bold nuts on the drive cable, one must be placed behind the cable retainer and one in front.

Fig. 4

Part-No: 106-4790

hook in the clutch lever

- 1 -

Modifications at the Handle

Speed“ the spring loaded in tension has a length of 30mm (Fig. 7)

Adjust the drive cable

30mm

Part-No: 95-6972

Fig.5 Fig. 5

1. Unhook the brake cable at the engine.

2. Remove the traction control rod retainer.

3. Pull the control handle to the rear, to get access to the left handle guide.

4. Remove the left handle guide (Fig.5).

5. Shift the Remove traction control bar to the left to remove the torsion spring on the right side. (Fig. 6).

6. Shift the Remove traction control bar to the right.

7. Install the control handle on the handle. Secure the traction control rod retainer.

8. Remove existing drive cable at the handle and install new one.

Make the final setting of the drive cable so that at „MAXand during pull back the rear wheels are not blocked.

10.

Install belt cover and lower grip.

11.

Run functional check.

key switch

Remove torsion spring

Abb. 6

Abb. 7

- 2 -