Toro 95-5898 Installation Instructions

FORM NO. 3319–537
PARKING BRAKE KIT
Model 30188 Traction Unit
for
PART NO. 95–5898
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
Brake assembly Bolt 3/8–16 x 1-1/4” (32 mm) Latch plate Bolt 1/4–20 x 3/4” (19 mm) Handle Bolt 5/16–18 x 1-1/2” (38 mm) Spacer Spring Flange locknut 5/16–18
1 4 1 2 1 1 1 1 1
Install parking brake
INSTALLATION
INSTRUCTIONS
Install Brake Assembly
1. Remove two bolts and locknuts per side,
securing pivot brackets to frame. Discard bolts only.
2. Position brake assembly around tank bracket
(Fig. 1). Secure with (4) new 3/8–18 x 1-1/4” (32 mm) bolts and previously removed 3/8” locknuts.
2
1
1. Brake assembly
2. Bolt 3/8–16 x 1-1/4” (32 mm)
3
2
m–3241
Figure 1
3. Locknut–re-use
1
Installation
Install Latch Plate
1. Remove bolts and locknuts securing right pivot
bearing to pivot bracket. Discard bolts only.
2. Position latch plate over holes and pivot bearing
behind plate. Secure with (2) new 1/4–20 x 3/4” (19 mm) bolts and previously removed 1/4” locknuts. (Fig. 2).
3
2
1
m–3242
Figure 2
1. Latch plate
2. Bolt 1/4–20 x 3/4” (19 mm)
3. Locknut–re-use
Install Handle
1. Slide handle down through latch plate and
position in channel of brake assembly.
2. Place 5/16-18 x 1-1/2” (38 mm) bolt through
channel, handle, spacer and spring (Fig. 3).
3. Secure bolt with 5/16” flange locknut (Fig. 3).
1
2
3
6
5
4
1. Handle
2. Channel
3. Bolt 5/16–18 x 1-1/2” (38 mm)
Figure 3
4. Spacer
5. Spring
6. Flange locknut 5/16”
m–3243
2
Loading...