Toro 94-3743 Installation Instructions
FORM NO. 3319–723
PTO BELT COVER INSTALLATION KIT
for 300 Series Garden Tractors
PART NUMBER 94–3743
INSTALLATION
INSTRUCTIONS
Note: Keep these Instructions with your tractor Operator’s Manual for future reference.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
PTO Belt Cover
Wing Nut – 1/4”-20
Knob
Retainer Nut– 1/4”-20 1
Belt Cover Bracket
Cap Screw – 3/8”-16 x 1” (25 mm)
Locknut – 3/8”-16
1
1
1
1
1
1
Attaching the belt cover to the retainer nut and
belt cover bracket
Attaching the belt cover to the tractor belt
guard
Attaching the belt cover bracket to the tractor
frame
Mounting the Belt Cover
Bracket
Fasten the belt cover bracket to the existing hole in
the tractor frame using the 3/8”-16 x 1” (25 mm) cap
screw and locknut (Fig. 1).
1
3
1. 3/8” Locknut
2. Belt Cover Bracket
3. Tractor Frame
2
4
m–2370
Figure 1
4. 3/8”-16 x 1” (25 mm) Cap
Screw
1
Installation
Installing the Retainer Bolt into
the Belt Guard
1. Remove the belt guard from the right side of the
tractor.
2. Cut out the hole template (Fig. 4) from the back
of this installation manual.
3. Fold the template tabs along the dotted lines,
then tape the hole template onto the belt guard
(Fig. 2).
4. Lay out, center–punch and drill a 5/16” hole in
the center of the square hole as marked on the
template (Fig. 2).
5. Use a file to open up the square hole as drawn on
the template (Fig. 2).
6. Snap the retainer nut into the square hole in the
belt guard from the back side of the guard
(Fig. 2).
7. Reinstall the belt guard and attached retainer nut
onto the tractor.
Installing the Belt Cover
1. Install the belt cover over the power take–off
(PTO) pulleys, and onto the 1/4”-20 stud on the
belt cover bracket (Fig. 3).
2. Install and tighten the wing nut onto the 1/4”-20
stud on the belt cover bracket (Fig. 3).
3. Install and tighten the knob into the retainer nut
on the belt guard (Fig. 3).
2
3
1
4
1
1. Belt Guard
2. Retainer Nut
3
Figure 2
2
4
3. Square Hole
4. Hole Template
m–3393
5
1. Retainer Nut
2. Belt Cover
3. Belt Cover Bracket
m–3394
Figure 3
4. Wing Nut
5. Knob
2
Loading...