Toro 93-9450 Installation Instructions
FORM NO. 3317–491
CE UPDATE KIT
ProLine 120 Model No. 30610
PART NO. 93–9450
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
Muffler guard
Bolt 5/16–18 x 1” (26mm)
Washer
Lock nut
Belt guard
Speed nut
Bolt 1/4–20 x 7/8” (22mm)
Lock bracket
Control block
1
2
2
2
1
1
1
1
1
Install muffler guard on left side of frame
Install belt guard under seat over opening
INSTALLATION
INSTRUCTIONS
Bolt 1/4–20 x 3” (77mm)
Spacer
Washer
Lock nut
Knob
1
1
2
1
1
Install lift lock
1
Installation
Muffler Guard
1. Align muffler guard with holes on left side of
frame (Fig. 1).
2. Secure to frame with (2) washers, (2) 26 mm
bolts and lock nuts (Fig. 1).
4
3
2
1
1. Muffler guard
2. washer
2
Figure 1
3. Bolt 5/16–18 x 1” (26mm)
4. Lock nut
3
2107
Install Lift Lock
1. Remove lower bolts from valve body.
2. Place control block rod through valve body from
inside (Fig. 3).
3. Place lift bracket slot over rod and install washer
and knob (Fig. 3).
4. Slide washer and spacer onto 77 mm bolt. Place
bolt through lift bracket hole, valve body and
control block (Fig. 3). Secure bolt with lock nut
(Fig. 3).
4
5
3
5
7
2
6
Install Belt Guard
1. Raise seat and remove center mounting screw.
2. Interlock rear lip of belt guard into rear of
opening (Fig. 2).
3. Secure belt guard with speed nut, slid over front
lip of belt guard, and 22 mm bolts (Fig. 2).
1
4
1. Belt guard
2. Rear lip
3
Figure 2
3. Speed nut
4. Bolt 1/4–20 x 7/8” (22 mm)
2
2108
1. Control block
2. Lock bracket
3. Bolt 5/16–18 x 3” (77 mm)
4. Spacer
Figure 3
1
5. Washer
6. Lock nut
7. Knob
2109
2
Loading...