Toro 93-3105 Installation Instructions

FORM NO. 3316-789

REINFORCING KIT

for 42” Mower Spindles

PART NO. 93–3105

INSTALLATION

INSTRUCTIONS

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

DESCRIPTION QTY. USE

Deck Plate-Center 1 Weld onto deck at center spindle.
Deck Plate-Outside 2 Weld onto deck at outer spindles.
Spindle Plate 3 Weld on top of each deck plate.
Washer 2 Spacer between deck and front mount.

Note: Care has been taken in locating deck and spindle plates on the mower deck so mounting holes will line

up with existing holes in the deck. Before welding double check that all holes line up and there will be
no interference.

Pre–Installation

1 Remove mower unit (see Operator’s Manual for

instructions).

2 Thoroughly clean mower deck. All debris must

be removed to ensure plates will fit properly
against mower deck.

3 Repair all bent or damaged areas of mower deck

and replace any missing parts.

The TORO Company – 1994

Printed in USA

All Rights Reserved

Installation Instructions

Installation

1 Remove belt covers, blades, anti-scalp cups,

spindles and all other brackets or hardware that
will interfere with deck plates from mower.

2 Remove front belt tightener plate from mower

(Fig. 2).

3 Place deck plates over center and outside spindle

openings as shown (Fig. 1). Align plate bolt
holes with bolt holes of mower deck spindle

openings (Fig. 1). Install spindles and clamp
deck plates securely in position with mounting
hardware previously removed.

4 Weld deck plates to mower at center and edges

with 1/8” weld bead 1” long at each – (Fig. 1).
Do not weld all around. Alternate from side to
side to prevent heat build–up and distortion of
mower.

Note: Too much heat concentration in one

are will cause mower warpage.

1

3

2

4

3

3

2

1542

Figure 1

1 Belt cover
2 Outside deck plate

2

3 Center deck plate
4 Spindle plate