Toro 78511 Installation Instructions

48in TURBO FORCE Mower Finishing Kit

Z400 Twin Soft Bagger

Model No. 78511

Setup

Important These instructions are for Z400 machines only.

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

Form No. 3352-634

Installation Instructions

Step

3 4

Description Qty. Use

No parts needed Removing the existing mower cover

Rear hinge bracket

Hex socket screw, 3/8 x 1-1/4

Flange nut, 3/8 inch

Bolt, 5/16 x 1 inch

Flange nuts, 5/16 inch

Mounting plate

Hex socket screw, 3/8 x 1-1/4 inch

Flange nuts, 3/8 inch

Pulley assembly 1 Installing the pulley assembly

Belt cover

Belt

Installing the anti-scalp roller and bracket

Installing the mounting plate

Installing the belt cover and Belt

Before Installation

Prepare the Mower

Perform the following procedure to prepare the mower for attaching the blower and finishing kit.

W 2004 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

1. Disengage the PTO, move the motion control levers to the neutral locked position and set the parking brake.

2. Stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.

3. Clean the mower of any debris on the deck or rear of mower to ease installation.

Original Instructions (EN)

Printed in the USA

Installation

Step

No Parts needed for this step.

Step

Parts needed for this step:

• 1 Rear hinge bracket

• 1 Hex socket screw, 3/8 x 1-1/4 inch

Removing the Existing Belt Cover

Note: Clean the area around the belt cover before removing.

1. Unlatch and remove the right belt cover (Fig. 1).

2. Store the right belt cover for later use. If the bagger

blower and pulley is removed it can be reused.

m–7799

Figure 1

1. Belt cover 2. Latch

• Flange nut, 3/8 inch

• 2 Bolts, 5/16 x 1 inch

• 2 Flange nuts, 5/16 inch

Installing the New Bracket and Anti-Scalp Roller

1. Install the rear hinge bracket using 2 bolts (5/16 x 1 inch) and 2 flange nuts (5/16 inch) (Fig. 2). Do not tighten at this time.

2. Install a hex socket screw (3/8 x 1-1/4 inch) into the deck and roller bracket (Fig. 2). Secure the screw with a flange nut (3/8 inch).

3. Tighten all fasteners.

1. Rear hinge bracket

2. Bolt, 5/16 3/8 x 1 inch

3. Flange nut, 5/16 inch

m–7800

Figure 2

4. Hex socket screw, 3/8 x 1-1/4 inch

5. Flange nut, 3/8 inch

+ 2 hidden pages