Rear Deector Kit
For TimeCutter® ZD Series Riding Mower
Model No. 74435
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Form No. 3356-697 Rev A
Installation Instructions
Step
1
Removing the Collection
Bag
No Parts Required
Procedure
Step
1
2
3
No parts required
Deector locking pin
Flange-head bolts
Deector
Hairpin cotter
Description
Qty.
–
2
4
1
2
Remove the collection bag.
Install the deector locking pins.
Install the deector.
Use
T he collection bag is retained in the engine co v er
b y seating the lev er side pin into a holed brac k et in
the right hand side of the engine co v er . R emo v e it
as follo ws:
1. P ark the mac hine on a flat, lev el surface , stop
the engine , remo v e the k ey , and w ait for all
mo ving par ts to stop .
2. Raise the bag up and first lift the pin in the
open notc h up and a w a y from the hood. T hen
slide the lev er side pin out the brac k et until the
bag is clear of the mac hine ( Figure 1 ).
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Figure 1
1. Collection bag 4. Collection bag pin
2. Engine hood 5. Notched bracket
3. Holed bracket
Printed in the USA.
All Rights Reserved
Step
Step
2
Installing the Deector
Locking Pins
Parts needed for this step:
2
Deector locking pin
4
Flange-head bolts
Procedure
With the pins facing outw ard, install the deflector
loc king pins to the bac k of the heat shield using 4
flang e-head bolts , as illustrated in Figure 2 .
3
Installing the Deector
Parts needed for this step:
1
Deector
2
Hairpin cotter
Procedure
1. Seat the right-hand pin located on top of the
deflector into the hole on top of the engine
hood, and then seat the opposing pin into the
notc h on the top of the engine hood ( Figure 3 )
Figure 2
1. Heat shield 3. Flange head bolt
2. Deector locking pin
Figure 3
2