Toro 74413, 74414, 74415, 74416, 74416TE Addendum

...

Adjusting the Push Arms

For Z 400 Z Masters

Model No. 74413, 74414, 74415, 74416, 74416TE, and 74417

Use the follo wing instr uctions when adjusting the push ar ms . Do not use the procedure in the Operator’ s Manual .

Adjusting the Push Arms

If needed, adjust the push ar ms to increase or decrease the mo w er belt tension.

1. Loosen the jam n ut and rotate the ball joint countercloc kwise , one tur n at a time ( Figure 1 ).

Form No. 3355-333 Rev A

Addendum

Figure 1

1. Push arm

2. 15–1/8 inch (384 mm)

3. Jam nut

4. Ball joint

2. Adjust eac h side the same amount. Eac h push ar m should ha v e a length of 15–1/8 inc h (384 mm) ( Figure 1 ).

Note: Increase the tension b y lengthening the push ar ms; decrease the tension b y shor tening the push ar ms .