Toro 74325 Setup Instructions

Form No. 3352-232

TimeCutter) Z Riding Mower

Setup Instructions

Use these instructions and procedures below when setting up this mower.

Important Refer to the Operator’s Manual for complete details on safety, operation, maintenance, and the warranty.

Setup

1. Lift the seat and verify that the positive battery cable
(red) is attached to the positive (+) battery terminal.
This will require slightly lifting the red terminal boot on
the battery end of the positive cable.

2. Attach the negative battery cable (black) to the negative
(–) battery terminal with the bolt and wing nut supplied.

3

2

5

1

6

4

m–7986

Figure 1

1. Battery

2. Red terminal boot

3. Positive battery cable

4. Negative battery cable

5. Bolt

6. Wing nut

3. Check engine oil level and verify that oil level is close
to, but not over the full mark on the engine dipstick.

1

2

m–6421

Figure 3

1. Height –of–cut lever 2. Highest position

5. Lift the seat and move the two bypass levers forward
and then outward to lock them in place as shown in
Figure 4. Place the motion control levers in the center,
unlocked position. Manually push the unit to the desired
location. Never tow the Toro TimeCutter Z.

3

4

1

2

3

2

1

1868

m–6439

Figure 2

1. Engine oil dipstick 2. Filler tube

4. Raise the mower height–of–cut lever to the highest
height–of–cut position for easier removal from wooden
skid.

W 2004 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196

1

1. Position for operating the

2. Position for pushing the

6. Lower the height–of–cut lever to the lowest position.

Original Instructions (EN)

m–7873

machine

machine

m–6561

Figure 4

3. Control levers in the
center, unlocked position

4. Bypass levers

Contact us at www.Toro.com

All Rights Reserved

Printed in the USA