Toro 74270 Addendum
Form No. 3326-254
Side Discharge Operation
Z147 Z–Master with 112 cm Mower
Model number: 74270—210000001 & Up
Addendum
Operator’s Manual
IMPORTANT: All of the following
instructions and list of loose parts are needed
for operating machine in side discharge
mode.
Keep this information with your operator manual.
Loose Parts
Note: Use the chart below to verify all parts have been shipped for side discharge operation.
Description Qty. Use
Grass Deflector
Bolt, 5/16 x 7–1/2 in.
Locknut, 5/16 in.
Spacer
1
1
1
1
Install grass deflector
Spring
Left Blowout Baffle
Right Blowout Baffle
Tapping screw
Side Discharge Blade 3 Using side discharge blades
The grass deflector for this machine was not installed
1
1
1
9
Using blowout baffle
Installing the Grass Deflector
at the factory. You will need to install the grass
deflector before using this machine in side discharge
mode.
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
grass deflector, a mulch plate, or an entire grass
catcher assembly.
1. Place spacer and spring onto grass deflector.
Using Side Discharge Blades
2. Place the grass deflector onto deck. Place the
“L” end of spring behind deck edge.
Note: Make sure the “L” end of spring is
installed behind deck edge before
installing the bolt as shown in figure 1.
3. Install bolt and nut. Place “J” hook end of spring
around grass deflector (Fig. 1).
IMPORTANT: The grass deflector must be
able to lower down into position. Lift the
deflector up to test that it lowers into the full
down position.
8
6
1
4
2
3
5
Side discharge blades are used when in side discharge
mode only.
Refer to Installing and Removing Blades in the
maintenance section of the operator manual.
IMPORTANT: Do not use side discharge
blades while in recycling mode.
m-5037
Figure 1
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Spring installed
6. Grass Deflector
7. “L” end of spring, place
behind deck edge before
installing bolt
8. “J” hook end of spring
Using Blowout Baffles
The blowout baffles are used when in side discharge mode
only.
Refer to Installing and Removing Blowout Baffles in the
operation section of the operator manual.
IMPORTANT: Do not use blowout baffles
while in recycling mode.
7
2
Loading...