Toro 70171 Addendum

FORM NO. 3322–593

Operator’s Manual

Model No. 70171–9900001 & UP

ADDENDUM

The following instructions have been revised. Keep this sheet with the Operator’s Manual for reference.

Loose

DESCRIPTION QTY. USE

Seat Wire Tie Clamp Seat Spacer (rubber) Seat Spacer (metal) Washer Screw Locknut

Front Wheel Assembly

Parts

, 5/16” I.D.

, 5/16”–18 x 1 1/2” (38 mm)

1 1 1 2

Install Seat

2 2 2 2

Flat W

asher Hub Cap Cotter Pin

Steering Wheel Roll Pin Steering Shaft Cover

Capscrew Wing Nut

Install

Seat

1. Thread 2 seat spacers (rubber) into bottom of

seat (Fig. 1) in rear holes.

2. Position seat onto seat base, inserting seat switch

cable thru slot and spacer studs through the rear mounting holes (Fig. 1). Secure loosely with two 5/16” locknuts.

2 2 2

1 1 1

2 2

Install Front Wheels

Install Steering Wheel Assembly

Secure battery cables to battery

3. Slide wire clamp over seat switch wire (Fig. 1).

4. Install 2 metal spacers in line with the front

holes. Insert a 5/16” x 1 1/2” (38 mm) screw through the wire clamp and a 5/16” flat washer. Insert this screw through the seat bracket and spacer into the left front seat hole (Fig. 1). Install another 5/16” x 1 1/2” (38 mm) screw with a flat washer into the right front seat hole.

International English (GB)

5. Adjust seat to desired position in the seat base

slots and tighten locknuts and screws.

6. Insert seat switch connector into wire harness

connector.

7. Secure wire harness to front of seat base with

wire tie.

1. Seat

4. Locknut

spacers (rubber) Wire clamp Seat switch wire

Seat switch slot Seat switch connector

Figure 1

Wire tie

Spacers (metal)

9. Washer

10. Screw (38 mm)



, 5/16” I.D.

, 5/16–18 x 1 1/2”