Toro 52207 Installation Instructions

1. Remove the top by pulling up on one edge.
2. Pull the burned out lamp straight out of the socket. Replace the new lamp by pushing a standard 12-watt No. 912 lamp (Toro model 52977) or the optional 18­watt No. 921 lamp (Toro Model 52976).
3. Replace the top onto the fixture by pressing it firmly in place and rotating it until the snaps align.
FORM NO. 3315–925
MODEL NO. 52207 39000001 & up
20-Watt Halogen Varifocus MiniSpot Light
®
®
6" minimum
One
Place cable over the contacts in the cable channel on the back of the fixture head. Press down firmly.
Two
Push the ground stake into the back of the fixture head. Insert the bolt through the fixture head and stake.
Three
Screw the knob onto the bolt to secure it and insert the cable into the slots in the side of the ground stake..
Five
To adjust the light beam from narrow to broad, turn the focus ring. Be careful not to touch the lens. When the fixture is operating, it becomes very hot.
Four
Make a hole in the ground about 8" deep. Do not push the stake into the ground without making a hole first or you may damage the stake. Insert the stake into the hold and push dirt around the stake. Do not hammer or press hard on the lamp-head assembly.
Lamp Replacement Procedure
Installation Procedure
The most important part of installing the
fixtures is making sure
their metal pins
pierce the wire inside
the cable:
You’ll know they’re
well-aligned and the
wire was pierced
when the light
comes on.
Misaligned
Piercing
Points
Correct
Piercing
Points
This
Not This
Loading...