Toro 52200 Installation Instructions

1. Insert the bulbs into the fixture.

Turn the ﬁxture ring and assembly counterclockwise while holding the base stationary. Lift the assembly off the base.

Insert the bulb by pushing straight down into the socket.

2. Attach the electrical cable to the ﬁxture.

Make sure the brass piercing points in the cable channel at the base of the ﬁxture are straight. Place the electrical cable over the piercing points and press the cable down ﬁrmly. (It may help to use something with a hard, ﬂat surface to press the wire into the piercing points.) If you have done this correctly, the ﬁxture should light. If it doesn’t, make sure the power pack is on (and the photocell covered to block light), the piercing points are straight, and try again. You can reposition the cable; the earlier holes caused by the piercing points will self-seal and not cause a hazard.

3. Attach the stake to the ﬁxture.

Slide the closed stake onto the ﬁxture base, locking the cable against the contacts (follow the arrow directions on the ﬁxture). The ﬁxture head should now be on the stake.

4. Run the cable through the stake.

Open the stake by pinching the locking tabs together.

Fold the cable into each side of the stake. Align the cable with the notches at the bottom of the stake and snap the stake closed.

INSTALLATION

GUIDE

FORM NO. 3315–918

MODEL NO. 52200 39000001 & up

Style Lites™ Walk Lights

5. Put the stake into the ground.

Make a hole in the ground for the stake. Don’t push the stake into the ground without making a hole ﬁrst because the stake could be damaged. After the stake is inserted, ﬁll around it with dirt. Do not hammer or press on the lamp ﬁxture assembly.

WARNING

! Possible Burns !

Do not attempt to remove any bulbs while the fixtures are on or you may be burned.

The most important part of

installing the ﬁxtures is

making sure their metal

pins pierce the wire inside

the cable:

You’ll know they’re wellaligned and the wire was

pierced when the light

comes on.

Misaligned

Piercing

Points

Correct

Piercing

Points

This

Not This

IMPORTANT: To ensure your power pack isn’t overloaded, use a replacement bulb with the same wattage as the original bulb. Maximum wattage allowed for this fixture is 12 watts.