Toro 30164, 30172TE, 30184, 30193, 30194 Installation Instructions

...

Form No. 3326-280

Fuel Tank Installation

Gear and Fixed Deck Mid–Size Mowers

Models: 30250—210000001 and Up 30252—210000001 and Up 30253—210000001 and Up 30254—210000001 and Up 30255—210000001 and Up 30257—210000001 and Up 30258—210000001 and Up 30259—210000001 and Up 30260—210000001 and Up 30172TE—210000001 and Up 30250TE—210000001 and Up 30164—200000001 and Up 30184—200000001 and Up 30193—200000001 and Up 30194—200000001 and Up 30196—200000001 and Up 30197—200000001 and Up

Model No.: See Below

1. Rear frame

2. Control panel

3. Align fuel tank with the top of the rear frame

(Fig. 1).

4. Place the transmission in neutral.

5. Align the control panel, side to side, so there is

1/16 in. (2 mm) space between panel and lever.

Operator’s Manual

Addendum

m–5221

Figure 1

3. Fuel tank

Keep this information with your operator manual. For models 30164, 30184, 30193, 30194, 30196 and

30197 refer to your operator manual to install shift lever. Disregard any information in this addendum about installing the control panel for these models.

Installing Fuel Tank

1. Remove the bolts and nuts holding the control

panel to the rear frame. Discard these nuts and bolts.

2. Slide the control panel over the shift lever and

under the bottom of the rear frame (Fig. 1).

6. Secure the right side control panel and fuel tank

to the rear frame (Fig. 2) with 2 bolts (5/16 x 7/8 in.), lock washers (5/16 in.) and washers (5/16 in.) (Fig. 2).

7. Secure the left side control panel and fuel tank to

the rear frame (Fig. 2) with 2 studs, washers (5/16 in.), springs and locknuts (5/16 in.) (Fig. 2).

Note: Tighten left side until it is completely

tight and then unscrew\ locknut one full turn. This will allow the spring to work.

m–5220

Figure 2

1. Bolt, 5/16 x 7/8 in.

2. Lock washers, 5/16 in.

3. Washer, 5/16 in.

4. Fuel line

5. Hose clamp

6. Stud

7. Spring

8. Locknut

9. Control panel

10. Fuel tank connection

8. Slide the hose clamp onto the fuel line (Fig. 2).

9. Push the fuel line onto the fuel tank connection

and secure it with a hose clamp (Fig. 2).

10. Shift lever to second gear and check alignment

of lever in slot of control panel. Clearance between top of lever and the top of the slot should be about equal to the clearance between bottom of the lever and the bottom of the slot.

11. If clearance is not correct, remove lever and bend

it slightly to adjust. Note: Do not bend lever while attached to

transmission shaft or damage may occur.