Toro 22452 Installation Instructions

Rear Stabilizer

for Dingo Traction Units

FORM NO. 3321-508

Model 22452

Loose

DESCRIPTION QTY. USE

Rear
W

Installation Instructions

Installing

Slide the stabilizer onto the operator platform
(Fig. 1).

Parts

stabilizer

arranty Registration Card

the Rear Stabilizer

1
1

1

Install on traction unit

Read before use

stabilizer allows the center of balance to shift from
the rear wheels to the stabilizer, thereby increasing
the downward force exerted by the auger.

To use the rear stabilizer, drive to the location where
you will be digging, then install the stabilizer, and
begin your work. Do not attempt to move the
traction unit with the rear stabilizer installed.

INSTALLATION

INSTRUCTIONS

2

1

Figure 1

1. Rear

Operating

The stabilizer is specifically designed for use with the
smaller diameter augers (i.e., less than 10 inches).
These augers may need extra weight to perform
effectively when digging in hard ground. The

Printed in USA

stabilizer

Notes

2.

Operator platform

m–3970



The T

oro Company – 1998

All Rights Reserved