Toro 19052 Installation Instructions

Form No. 3325-227 Rev A
Operator Shield Guard Kit
Twister Utility Vehicle
Model No. 19052
Installation
1. Position the machine on a level surface. Set the parking
brake, turn the ignition off, and remove the key.
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure you or other bystanders.
Remove the key from the ignition switch before you do any maintenance.
2. Slide the shield into the slots at the front of the cargo
bed (Fig. 1).
3. Using the shield bracket holes as a guide, drill 2 holes
(11/32 in. diameter) through the cargo bed.
4. Secure the shield with the 2 bolts and flange nuts
(Fig. 1). Torque the bolts to 175–225 in.-lb. (20–25 N⋅m) m–5457
2
3
1. Shield
2. Bolt
1
Figure 1
3. Flange nut
2001 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196
All Rights Reserved
Printed in the USA
1
Loading...