Toro 132-3127 Parts Catalogue
Form No. 0453-747
Arctic Cat® Prowler
Installation Instructions - Accessory Kit
LXC Windshield Washer Kit
(1436-523)
NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Kit includes:
p/n QTY DESCRIPTION
2441-262 1 Tank (A)
2441-263 1 90 ° Adaptor (B)
2441-264 1 Check Valve (C)
N/A 2 Machine Screw (D)
N/A 2 Washer (E)
N/A 6 Cable Tie (G)
0453-747 1 Instruction
2441-265 1 Sprayer (F)
2441-266 1 Washer Tube (H)
N/A 2 Nut (I)
2441-267 1 Pump
2441-268 1 Wire Harness
4. Place the tank into the operator’s side of the underhood storage box and mark both mounting locations.
5. Remove the tank and using a 1/4-in. drill bit, drill
both mounting locations. See Fig. 2.
Fig. 2
1. Open the hood; then cut 8-in. of Washer Tube and
install it on pump until it is fully seated.
2. Install Check Valve to the other side of the 8-in. washer
tube making sure the arrow is in the direction flowing
away from the Tank. See Fig. 1.
Fig. 1
UTV-232
3. Install the rest of the washer tube on the other side
of the check valve.
UTV-233
6. Connect both the black and red wires to the pump
mounted on the back of the tank; then secure the
tank to the storage box using two Machine Screws,
two Washers, and two nuts. Tighten securely. See
Fig. 3.
Fig. 3
UTV-234
1
7. Make sure all wires are between the dash and the
gutter of the storage box. Use cable ties to maintain
all wires. See Fig. 4.
10. Route the washer tube from the pump under the
dash and up along the left-side ROPS tube and
toward the wiper motor.
Fig. 4
UTV-235A
8. Remove the two machine screws securing the top of the
dash to the frame; route the red wire from the pump to
upper left tab of the switch from the windshield wiper
kit.
9. Route the black wire from the pump to the same mounting location as the black wire from the wiper motor.
Secure the dash to the frame using existing machine
screws. See Fig. 5.
Fig. 5
11. Remove the plug above the wiper motor; then install 90°
Adaptor into the windshield; then connect the washer
tube to the adaptor. See Fig. 6.
Fig. 6
UTV-240A
12. Install Sprayer onto the wiper arm; then plug the
sprayer tube into the 90° adaptor. See Fig. 7.
Fig. 7
UTV-241
13. Fill the tank with appropriate window washer fluid
UTV-236
NOTE: Cut a 9-in. section of washer tube which
will be routed from the 90° adaptor to the sprayer.
Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 0711
and test the function of the sprayer.
2
Loading...