Toro 132-3126 Parts Catalogue
Form No. 0453-746
Arctic Cat® Prowler
Installation Instructions - Accessory Kit
LXC Windshield Wiper Kit
(1436-522)
NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Kit includes:
p/n QTY DESCRIPTION
2441-269 1 Wiper Motor (A)
2441-270 1 Wiper Arm (B)
2441-271 1 Black Wire (C)
2441-272 1 Red Wire (108 1/4-in.) (D)
2441-273 1 Jumper Wire (E)
2441-274 1 Accessory Wire-Jumper (F)
(23 5/8-in.)
2441-275 1 Loom (G)
2441-276 1 Switch (H)
2441-277 1 Blade (I)
N/A 6 Cable Tie (J)
0453-746 1 Instruction
2. Position Wiper Motor through the three holes in
the windshield; then secure the motor using three
flat washers and three nuts.
3. Install Blade onto Wiper Arm; then secure the arm
and the upper portion of the wiper motor to the
windshield (at a 90° angle) using one nut. Finger
tighten at this time. See Fig. 2.
Fig. 2
NOTE: Make sure the key is in the off position
while installing this kit.
1. With the windshield kit installed on the vehicle, remove
the three lower caps from the middle of the windshield.
See Fig. 1.
Fig. 1
UTV-223A
UTV-224A
4. Install the Black and Red Wire (108 1/4-in.) into
Loom; then plug the wires into the wiper motor.
See Fig. 3.
Fig. 3
UTV-226A
1
5. Route the loom along the upper portion of the
windshield and down along the left-side ROPS
tube. Loosely secure using cable ties. See Fig. 4.
9. Route the accessory wire-jumper through the dash
and plug it into the upper left switch connection
(#4). See Fig. 7.
Fig. 4
UTV-227A
6. Route the wiper motor wires on the left side of the
dash and route to the switch panel in the dash.
7. With the hood open, remove the two machine
screws securing the middle of the dash to the
frame. See Fig. 5
Fig. 5
Fig. 7
UTV-252
10. Route the red wire through the dash and plug it into
the lower left switch connection (#3).
11. Route the black wire from the wiper motor and
secure between the dash and the frame using one of
the self-tapping screws removed in step 7. See Fig.
8.
Fig. 8
UTV-243A
8. Route Accessory Wire-Jumper (23 5/8-in.) into the
accessory plug located under the dash next to the
key switch connection. See Fig. 6.
Fig. 6
UTV-225A
UTV-229A
12. Press the switch into the dash until it is fully
seated; then test the function of the wiper.
NOTE: If existing switch mount is full, use template below to install the switch to the right of the
existing switch mount. Panel Switch Mount Kit (p/n
1436-008) can also be ordered and installed. See
Fig. 9.
2
Loading...