Toro 112-1792 Installation Instructions
Form No. 3356-133 Rev A
Discharge Side Rear Anti-Scalp Roller Kit
For Z Master Mowers
Model No. 112–1792
Installation Instructions
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
T his kit is for Z400 Z Masters with 52 inc h mo w er
dec ks and Z500 Z Master Estate Models .
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
2
Step
1
Preparing the Mower
No Parts Required
Description
No parts required
Inside mounting plate
Outside mounting plate
Carriage bolt (3/8 x 3/4 inch)
Nut (3/8 inch)
Bolt (3/8 x 4–1/2 inches)
Anti-scalp roller
Bushing
Spacer
Step
2
Installing the Anti-scalp
Roller and Brackets
Qty.
–
1
1
4
5
1
1
1
1
Prepare the mower.
Install the new mounting plate.
Use
Procedure
1. T horoughly clean mo w er dec k. All debris m ust
be remo v ed to ensure the mounting brac k et
will fit properly ag ainst mo w er dec k.
2. R e pair all bent or damag ed areas of mo w er
dec k and re place any missing par ts .
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Parts needed for this step:
1
Inside mounting plate
1
Outside mounting plate
4
Carriage bolt (3/8 x 3/4 inch)
5
Nut (3/8 inch)
1
Bolt (3/8 x 4–1/2 inches)
1
Anti-scalp roller
1
Bushing
1
Spacer
Procedure
1. Loosely install the inside brac k et to the mo w er
dec k with 2 car riag e bolts (3/8 x 3/4 inc h) and
2 n uts (3/8 inc h) as sho wn in Figure 1 .
Printed in the USA.
All Rights Reserved
Do not tighten these bolts . T hese will be
tightened after all par ts are loosely installed.
2. Loosely install the outside brac k et to the
mo w er dec k with 2 car riag e bolts (3/8 x 3/4
inc h) and 2 n uts (3/8 inc h) as sho wn in Figure
1 .
Do not tighten these bolts . T hese will be
tightened after all par ts are loosely installed.
3. Install the anti-scalp roller , spacer , and bushing
betw een the tw o mounting brac k ets with a bolt
(3/8 x 4–1/2 inc hes) and n ut (3/8 inc h)( Figure
1 ).
Figure 1
1. Carriage bolt (3/8 x 3/4
inch)
2. Outside bracket 6. Bushing
3. Nut (3/8 inch)
4. Bolt (3/8 x 4–1/2 inches)
5. Anti-scalp roller
7. Spacer
8. Inside bracket
4. Tighten the bolts holding the mounting
brac k ets to the mo w er dec k ( Figure 1 ).
5. Tighten the bolt for the anti-scalp roller .
2
Loading...