Toro 110-2025 Installation Instructions

40in Bagger Enhancement Kit

For 2006 and After Mid-Size Mowers

Model No. 110–2025

Loose Parts

Use the chart below to verify that all parts have been shipped.

Form No. 3354-112 Rev A

Installation Instructions

Step

1

2

No parts required

Right side rubber bafe
Left side rubber bafe
Left metal bafe stiffener
Carriage bolt (5/16 x 1 inch)
Locknut (5/16 inch)
Right metal bafe stiffener

Description

Step

1

Preparing the Mower Deck

No Parts Required

Procedure

1. P osition the mo w er on a flat surface .

Qty.

–

1
1
1
8
8
1

Mechanical or h y draulic jacks may f ail to
suppor t the machine and cause a serious
injur y .

• Use jack stands when suppor ting the
machine.

• Do not use h y draulic jacks.

Prepare the mower deck for
installation.

Install the bafes.

Use

Step

2. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .

3. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.

4. Lift the front of the mac hine and suppor t the
mac hine using jac k stands .

5. T horoughly clean the mo w er dec k. All debris
m ust be remo v ed to ensure the baffle will fit
properly ag ainst the mo w er dec k.

6. R e pair all bent and damag ed areas of the
mo w er dec k and re place any missing par ts .

© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420

Register at www.Toro.com. Original Instructions (EN)

2

Installing the Bafes

Parts needed for this step:

1

Right side rubber bafe

1

Left side rubber bafe

1

Left metal bafe stiffener

8

Carriage bolt (5/16 x 1 inch)

8

Locknut (5/16 inch)

1

Right metal bafe stiffener

Procedure
Note: Install bolts as sho wn in Figure 1 .

Printed in the USA.
All Rights Reserved

Note: T here are different ends on the left and

right metal baffle stiffeners . See Figure 1 to
identify the difference betw een the left and right
metal stiffeners .

1. Install the left side r ubber baffle and the left
metal baffle stiffener with 4 bolts (5/16 x 1
inc h) and 4 loc kn uts (5/16 inc h) ( Figure 1 ).

2. Install the right side r ubber baffle and the right
metal baffle stiffener with 4 bolts (5/16 x 1
inc h) and 4 loc kn uts (5/16 inc h) ( Figure 1 ).

3. R otate the cutting blades and mak e sure they
do not hit the baffles .

Figure 1

1. Mower deck

2. Locknut (5/16 inch)

3. Left side rubber bafe 7. Left metal bafe stiffener

4. Right metal bafe stiffener 8. Note the different ends on

5. Carriage bolt (5/16 x 1
inch)

6. Right side rubber bafe

bafes

2