Toro 108-8137 Installation Instructions

Form No. 3354-107 Rev A

Discharge Door Seal Kit

Model No. — All 2005 and after Super Recycler Lawn Mower Models

Installation Instructions

Installing the Door Seals

Parts needed for this step:

2

Door seals

Procedure

1. Install the seal onto one of the two top edges
on the discharge door (Figure 1).

1

2

1
2

Installing the Foam Side
Pieces

Parts needed for this step:

1

Foam piece

Procedure

1. Cut the foam piece in half so that you have two
1-inch by 1-1/2–inch pieces.

2. Remove the protective backing from one of
the foam pieces to expose the adhesive.

3. Lift up the rear discharge door.

4. Attach a foam piece to one of the corners on
the inside of the discharge door (Figure 2).

1 1

G001299

Figure 1

1. Seal 2. Top edge

Note: Start on the outer end of the edge and
work your way inward, using your thumb to
firmly push the seal onto the edge.

2. Install the other seal onto the other top edg e
of the discharge door.

© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420

Register at www.Toro.com. Original Instructions (EN)

G001300

Figure 2

1. Foam piece

5. Removetheprotectivebackingfromtheother
foam piece and attach it to the other corner on
the inside of the discharge door (Figure 2).

Printed in the USA.
All Rights Reserved