Toro 108-7338 Installation Instructions
Lower Shroud Replacement Kit
2002–2005 CCRt 2450 and 3650 GTS
North American Snowthrowers
Part No. 108-7338
Installation Instructions
Form No. 3353-673 Rev B
Contents of the Kit
DESCRIPTION QUANTITY
Lower shroud 1
Heat shield cover 1
Choke shield 1
Rubber spring cover 1
Spring 1
Cable 1
Cable adjuster 1
Removing the Lower Shroud from
the Snowthrower
1. Remove the 2 screws that secure the lower
shroud to the snowthrower.
Note: Save the screws you removed to secure the
new lower shroud to the snowthrower.
Removing the Old Cable
Components
CCR 3650 GTS Models only
1. Unhook the
Z-fitting end of the
cable from the
control bar.
2. Unhook the other (spring) end of the cable.
3. Open up the cable guide on the handle and
remove the cable.
4. Discard the old cable, spring, adjuster, and rubber
spring cover.
Installing the New Lower Shroud
onto the Snowthrower
1. Install the new choke seal.
A
2. Pull the top of the shroud to the rear until the
choke lever (A above) clears the slot.
3. Remove the shroud and discard it.
4. Remove the rubber choke shield from the choke
lever and discard the shield (if applicable).
2005—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Printed in the USA
All Rights Reserved
1.
2.
2. As you install the new lower shroud onto the
snowthrower, guide the choke lever through the slot.
Original Instructions (EN)
Register your product at www.Toro.com
2
3. Secure the new lower shroud with the 2 screws
you previously removed.
Note: Ensure that the lip of the new lower shroud
(A) rests on top of cross tube (B) of the
snowthrower.
A
B
Installing the New Cable
Components
CCR 3650 GTS Models only
1. Install the Z-fitting end of the new cable in the
hole where you removed the spring (at the bottom of
the snowthrower) in step 2 of Removing the Old
Cable Components.
2. Insert the cable into the cable guide and install
the cable guide.
3. Attach the new adjuster to the cable.
Note: Insert the Z-fitting into the third hole from
the lower end of the adjuster.
4. Attach the new spring to the end of the adjuster.
5. Adjust the cable according to the instructions in
the Operator’s Manual.
6. Install the rubber cover over the new spring and
adjuster.
7. Hook the cable spring into the bottom hole of the
control bar.
Installing the Heat Shield Cover
Install the heat shield cover over the vent openings as
shown and carefully snap the cover into place.
Note: Insert the tabs of the cover into the vent
openings so that the cover is up and back, then
gradually slide the cover down and forward as you
insert the hooks (B) on the cover into the vent
openings.
1.
A
2.
B
3.
B
Loading...