Toro 108-4796 Installation Instructions
Discharge Tunnel Replacement Kit
Part No. 108-4796
Installation Instructions
Form No. 3352-330
1. Remove the 2 bolts and 2 locknuts that hold the old
discharge tunnel onto the mower housing.
Note: If possible, save the bolts and locknuts for
installing the new discharge tunnel.
2. Remove the old discharge tunnel from the mower
housing and discard the tunnel (Fig. 1).
2
1
m–7831
3. Position the new discharge tunnel onto the mower
housing (Fig. 2).
1
1
m–7832
Figure 2
1. New discharge tunnel
Figure 1
1. Mower housing (without
the discharge tunnel)
W 2004 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
2. Exposed blade
Note: Insert the front of the tunnel into the opening.
4. Insert the 2 bolts that you previously removed through
the rear holes of the new discharge tunnel and the
mower housing (Fig. 3).
1
1. Bolt (2)
Original Instructions (EN,F)
m–7833
Figure 3
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
5. Install the locknuts that you previously removed from
under the housing and tighten them to 80 inch-lb (until
they are snug).
9. Hook one end of the spring (provided in the kit) through
the small hole in the plate.
6. Drill 2 holes (7/32 inch dia.) in the mower housing
using the left and right side holes in the discharge
tunnel as guides.
7. Insert a self-tapping bolt (provided in the kit) into the
right side hole in the discharge tunnel and tighten it to
80 inch-lb (until it is snug) as shown in Figure 4.
1
m–7834
4
2
3
m–7836
Figure 6
1. Small hole in the plate
2. Plate and bolt
3. Spring
4. Door lever arm
10. Hook the other end of the spring through the hole in the
door lever arm (Fig. 6).
11. Insert the door into the opening of the discharge tunnel.
1
Figure 4
1. Right side hole (covered by the wrench)
8. Install the plate (provided in the kit) to the mower
housing using a bolt in the kit through the left side hole
in the discharge tunnel. Tighten the bolt to 80 inch-lb
(until it is snug) as shown in Figure 5.
1
Figure 5
1. Bolt
2. Plate
3. Left side of tunnel
2
m–7835
1
2
m–7841
3
Figure 7
1. Door
2. Discharge tunnel
3. Raised door stop
3
Note: Ensure that the door is inside the raised door stop
(Fig. 7).
Note: Position the uplifted bend in the plate rearward.
2
12. Slip the wire loop on the discharge tunnel over the outer
end of the door hinge (Figs. 8 and 9).
3
13. Install the bracket on the discharge tunnel with 2 bolts
provided in the kit (Fig. 10).
1
1. Wire loop
2. Outer end of door hinge
Figure 8
2
3. Door
1
2
m–7837
m–7840
Figure 10
1. Bracket 2. Bolt (2)
14. The new discharge tunnel should appear on the mower
housing as shown in Figure 11.
1
Figure 9
1. Outer end of door hinge in wire loop
m–7838
m–7841
Figure 11
3
Loading...