Toro 108-4657 Installation Instructions
Rear Cover Kit
For TX Series Compact Utility Loader
Model No. 108-4657
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Form No. 3353-884 Rev A
Installation Instructions
Step
1
2
3
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Note: T his installation of this kit will require drilling holes into the mac hine c hassis . A v oid damaging
the mac hine b y understanding what is behind the surface to be drilled and tak e precaution not to har m
any inter nal par ts .
No parts required
Cover support, left side
Cover support, right side
Bolt, (1/4 x 3/4 inch)
Cover, rear
Rivet
Washer, back
Knob
Washer
Ring, retaining
Description
Qty.
–
1
1
6
1
2
2
2
2
2
Prepare the Machine
Install the side cover supports.
Install the rear cover.
Use
Step
1
Preparing the Machine
No Parts Required
Procedure
Lo w er the loader ar ms , stop the engine and
remo v e the k ey .
1. Open the rear co v er b y unlatc hing the fastener
on the left side of the mac hine ( Figure 1 ).
2. R emo v e the fasteners securing the latc h to the
mac hine . Discard latc h and fasteners ( Figure
1 ).
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved
the fasteners and co v er . R etain the Operator’ s
Manual housing tube and clamps .
5. R emo v e the fasteners securing the hing e co v er
and hing e to the mac hine ( Figure 2 ). R emo v e
the hing e co v er , hing e , and fasteners and
discard.
Step
2
Installing the Side Cover
Figure 1
1. Latch
2. Rear cover
3. Fastener
4. Latch plate
3. One the right side of the mac hine , remo v e the
fasteners securing the hing e plate to rear co v er
( Figure 2 ). Discard the fasteners .
Supports
Parts needed for this step:
1
Cover support, left side
1
Cover support, right side
6
Bolt, (1/4 x 3/4 inch)
Procedure
1. Locate the left and right side co v er suppor ts
in the loose par ts .
2. On the left side of the mac hine , measure and
mark at the location as sho wn in Figure 3 .
Measure 2-7/8 inc h bac k from the frame edg e
along the base of the control panel frame and
1/2 inc h up .
Figure 2
1. Rear cover
2. Washer 6. Lock nut
3. Hinge
4. Machine frame
5. Bolt
7. Hinge plate
4. R emo v e the fasteners securing the R-clamp
and Operator’ s Manual tube to the co v er . Discard
2
Loading...