Toro 108-4140, 108-4141 Installation Instructions

Trim/Discharge Side Anti-Scalp Roller Kit

For Z400 Series Z Master® Mowers

Model No. 108-4140 Model No. 108-4141

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.

Form No. 3353-909 Rev A

Installation Instructions

Step

Installing the Wheel Bracket

Parts needed for this step:

Wheel bracket

Carriage bolt (3/8 x 3/4 inch)

Flange nut (3/8 inch)

Description

Wheel bracket Carriage bolt (3/8 x 3/4 inch) Flange nut (3/8 inch) Wheel Bolt (3/8 x 4-3/4 inches) Long spacer 1 Short spacer Flange nut (3/8 inch)

2. Install the wheel brac k et to the mo w er using 3 car riag e bolts (3/8 x 3/4 inc h) and ﬂang e n uts (3/8 inc h) ( Figure 1 ).

Important: Ensur e that y ou install the car ria ge bolts with the bolt heads on the inside of the mo w er and the n uts on the outside.

Qty.

1 3 3 1 1

1 1

Install the wheel bracket.

Install the wheel.

Use

and remo v e the three bolts and n uts that are installed in the holes .

Procedure

1. Pre pare the installation site as follo ws:

• If y ou are re placing an existing anti-scalp wheel, remo v e the wheel, wheel brac k et, and all fasteners from the mo w er and discard them.

• If y ou are installing the anti-scalp wheel for the ﬁrst time , locate the three holes on the rear trim or disc harg e side of the mo w er (de pending on whic h kit y ou are installing)

1. Wheel bracket

2. Carriage bolt (3/8 x 3/4 inch)

3. Flange nut (3/8 inch)

4. Wheel

spacer/wheel assembly at the desired height ( Figure 1 ).

Note: Inser t the bolt so that its head is to w ard the outside of the mo w er .

4. Secure the wheel with a ﬂang e n ut (3/8 inc h) ( Figure 1 ).

Figure 1

5. Bolt (3/8 x 4-3/4 inches)

6. Short spacer

7. Long spacer

Step

Installing the Wheel

Parts needed for this step:

Wheel

Bolt (3/8 x 4-3/4 inches) 1 Long spacer 1

Short spacer 1

Flange nut (3/8 inch)

Procedure

1. Slide the long spacer into the wheel ( Figure 1 ).

2. Place the shor t spacer inside the wheel hub on the side of the wheel with the shor t hub ( Figure 1 ).

3. Place the wheel into the wheel brac k et and push the bolt (3/8 x 4-3/4 inc hes) through the brac k et, shor t spacer , and the long