Toro 108-4091 Installation Instructions

Bagging Enhancement Kit

Z400 Series Z Master Mowers

Part No. 108–4091

Installation Instructions

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Form No. 3353–234

Right side rubber baffle Left side rubber baffle Metal baffle stiffener Carriage bolt, 5/16 x 1 inch Locknut, 5/16 inch

Preparing the Mower Deck

1. Position the mower on a flat surface.

2. Disengage the PTO, move the motion control levers to

the neutral locked position and set the parking brake.

3. Stop the engine, remove the key, and wait for all

moving parts to stop before leaving the operating position.

4. Raise the mower to the transport position.

5. Lift the front of the machine and support the machine

using jack stands.

6. Thoroughly clean the mower deck. All debris must be

removed to ensure the baffle will fit properly against the mower deck.

1 1 2 8 8

Installing the baffles

7. Repair all bent and damaged areas of the mower deck

and replace any missing parts.

Warning

Mechanical or hydraulic jacks may fail to support the machine and cause a serious injury.

• Use jack stands when supporting the machine.

• Do not use hydraulic jacks.

 2004 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

Original Instructions (EN)

Printed in the USA

Installing the Baffles

Note: Install bolts as shown in Figure 1.

1. Install the left side rubber baffle and one of the baffle

stiffeners with 4 bolts (5/16 x 1 inch) and 4 locknuts (5/16 inch) (Fig. 1).

2. Install the right side rubber baffle and one of the baffle

stiffeners with 4 bolts (5/16 x 1 inch) and 4 locknuts (5/16 inch) (Fig. 1).

3. Rotate the cutting blades and make sure they do not hit

the baffles.

1. Mower deck

2. Left side rubber baffle

3. Right side rubber baffle

4. Baffle stiffener

m–7913

Figure 1

5. Carriage bolt, 5/16 x 1 inch 6. Lock Nut, 5/16 inch