Toro 108-2639, 108-2640 Installation Instructions
Blower Liner Kit
For Z400 and Z500 Twin and Triple Baggers
Model No. 108–2639
Model No. 108–2640
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Form No. 3353-411 Rev A
Installation Instructions
Step
Blower liner
Fanged elevator bolt
1
Flat washer
Locknut
Description
Step
1
Parts needed for this step:
1
Blower liner
5
Fanged elevator bolt
5
Flat washer
5
Locknut
Procedure
1. Diseng ag e the PTO , set the parking brak e , and
c hoc k or bloc k the dri v e wheels .
Qty.
1
5
Replacing the Blower Liner
5
5
T he new liner and f anged elev ator bolts
may ha v e shar p edges which could cut y our
hands or cause sli v er s. W ear g lo v es when
handling them.
7. Secure the liner to the rear of the blo w er with 3
fang ed elev ator bolts (5/16 x 1 inc h), flat w ashers
and loc kn uts (5/16 inc h) ( Figure 1 ).
Use
2. T ur n off the engine , remo v e the k ey , and w ait for all
mo ving par ts to stop before lea ving the operating
position.
3. R emo v e the fiv e bolts that hold the blo w er liner
to the blo w er ( Figure 1 and Figure 2 ). Discard the
hardw are .
4. Pull the liner out of the blo w er ( Figure 1 ).
Note: Do not use y our hands to remo v e the
debris .
5. R emo v e any debris from the blo w er .
6. Slide the new liner around the blo w er impeller .
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Figure 1
1. Blower 4. Washer, 5/16 inch
2. Liner
3. Fanged elevator bolt, 5/16
x 1 inch
5. Locknut, 5/16 inch
Printed in the USA.
All Rights Reserved
8. Install 2 fang ed elev ator bolts (5/16 x 1 inc h), flat
w ashers and loc kn uts (5/16 inc h) into the liner and
the blo w er ( Figure 2 ).
Figure 2
1. Blower 3. Nut, 5/16 inch
2. Fanged elevator bolt, 5/16
x 1 inch
4. Impeller
10. W hile holding the liner , tighten the 2 top bolts in
the liner and the blo w er ( Figure 3 ).
11. R otate the blo w er pulley to v erify that the blo w er
fan does not hit the liner ( Figure 3 ). Adjust the
liner if necessar y .
9. Using a bloc k of w ood, push the liner do wn to w ard
the front of blo w er , until the blo w er liner tightly
confor ms to the inside of the blo w er ( Figure 3 ).
T his will pro vide clearance betw een the impeller
and the liner .
Figure 3
1. Blower 3. Wood block
2. Top bolt and nut
2
Loading...