Toro 107-1633 Installation Instructions

Hose Kit

DFS Vac Collection System for 500 Series Z Master

Model No. 107-1633

Installation Instructions

Use this kit to replace the rigid tubes of your bagging system with a flexible hose.

Loose Parts

Note: Use the chart below to identify parts for assembly.

Description Qty. Use

Form No. 3350-485

Handled tube Hose clamp Hose

Installing the Hose Kit

1. Disengage the PTO and set the parking brake.

2. Stop the engine, remove the key, and wait for all

moving parts to stop before leaving the operating position.

3. Remove and store the long middle tube, clamp, and

upper tube that came with your bagger (Fig. 1).

1 1 1

Installing the hose kit Installing the hose kit Installing the hose kit

M–7117

Figure 2

1. Hose

2. To bagger

3. Clamp

4. Handled tube

5. Boot

6. Latch

Figure 1

1. Long middle tube

2. Upper tube

 2003 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

3. Clamp

M–6910

Original Instructions (EN)

4. Fully open the clamp and slide it onto the handled tube

(Fig. 2).

5. Slide the hose over the end of the handled tube,

ensuring that it is over the ridges on the tube and extends onto the tube far enough so that it touches the handle (Fig. 2).

6. Tighten the clamp around the hose and handled tube

connection (Fig. 2).

7. Slide the handled tube onto the boot and latch them

together (Fig. 2).

8. Install the end of the hose into the bagger (Fig. 2).

Printed in the USA