Toro 106-7723 Installation Instructions

Track Kit
Model No. 106-7723
Determine the left and right sides of the traction unit from the operator’s position.
Loose Parts
Description Qty. Use
Form No. 3353-882 Rev A
Installation Instructions
Track
Road wheel
Snap ring, internal
Gasket
Wheel cap
Track Kit:
The following procedure depicts the track updatet on the left-hand side; however, it can be used to update the track on either side.
Preparing the machine
1. Lower the loader arms, stop the engine, and remove the key.
2. Lift/support the side of the unit to be worked on so that the track is three to four inches (7.6 to 10 cm) off of the ground.
3. Remove the track from the machine. Refer to the Operator’s Manual for more information.
4. Remove the track guide gain access to the road wheels by removing the four bolts (1/2 x 1-1/4 inch) and four lockwashers (1/2 inch) as shown in Figure 1.
5. Remove the snap ring and wheel cap to access the bolts securing the road wheel to the track guide and discard.
1
10
10
10
10
Install the track kit
1
2
m–7735
1. Bolt, 1/2 x 1-1/14 inch
2. Lockwasher, 1/2 inch
3. Track guide assembly
3
Figure 1
Left-hand side shown
1
2
4
1
2
5
1
2
4. Frame
5. Notch, toward the rear of machine
6. Remove the bolt and wheel assembly and discard.
7. Repeat steps for all ten road wheels.
W 2005 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196
Original Instructions (EN)
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
Installing the Road Wheels
Assemble the wheels as shown in Figure 2.
1. Add grease between the bearing and the seal behind the wheel (Fig 2).
2. Install the new road wheel onto the track guide using the gasket in the kit and a new bolt (5/8 x 1-1/2 inch) as shown in Fig. 2.
3. Torque the road wheel bolt to 135 to 165 ft-lb (183 to 223 N⋅m).
4. Fill the road wheel cap with grease and place it over the bolt head (Fig 2).
5. Secure the road wheel cap with a snap ring (Fig 2).
1
2
3
4
7
m–7731
6
Figure 2
1. Track guide
2. Wheel
3. Gasket
4. Bolt, 5/8 x 1-1/2 inch
5. Wheel cap, add grease under the cap
6. Snap ring
7. Add grease behind the wheel between the bearing and the seal
6. Repeat Steps 1–5 for all ten wheels.
7. Install the track guide assembly to the machine using
four bolts (1/2 x 1-1/4 inch) and four lock washers (1/2 inch) down through the frame to the track guide assembly (Fig. 1).
5
Important Ensure the notch in the track guide is
pointing toward the rear of the machine.
8. Install the new track to the machine. Refer to the Operator’s Manual for more information.
9. Lower the traction unit to the ground.
2
Loading...