Anti-Scalp Roller Kit
38 and 42 inch Mowers for TimeCutter Z Riding Mower
Model No. 106–7020 and 106–7027
Installation Instructions
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts for assembly.
Description Qty. Use
Form No. 3329–343
Gage wheel bracket, front right
Gage wheel bracket, front left
Gage wheel
Wheel bolt
Lock nut, 3/8 inch
Bolt, 5/16 x 5/8 inch
Flange nut, 5/8 inch
Bolt, 5/16 x 5/8 inch
Flange nut, 5/8 inch
Assembling the Gage Wheels
1. Assemble the gage wheel and the bracket using the
wheel bolt and lock nut, 3/8 inch (Fig. 1). Use the same
hole for both brackets.
2. Repeat step one for the other bracket and wheel.
3
2
1
1
2
2
2
6
6
4
4
Assembling the gage wheels
Installing the gage wheel bracket, 38 inch
Installing the gage wheel bracket, 42 inch
Adjusting the Gage Wheels
The front mower wheels are to guide the mower over
uneven ground. The front wheel height can be changed to
closely match the selected height of cut for the mower.
1. To change the height of the mower front wheels,
remove the wheel mounting bolt and change the hole
into which the wheel is mounted (Fig. 1).
2. Use the top hole for the lowest cutting height and the
bottom hole for higher cutting heights (Fig. 1).
m–6670
Left gage wheel assembly for 42 inch deck shown
1. Gage wheel
2. Gage wheel bracket
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
1
Figure 1
3. Locknut
4. Wheel bolt
4
All Rights Reserved
Printed in the USA
1
Installing the Wheel Brackets
1. Stop the engine and remove the ignition key.
2. Raise the mower to the G position [4-1/2 inch
(114 mm)]. See the mower Operator’s Manual for
raising the mower.
3. Mount the brackets onto the deck using the bolts, 5/16 x
5/8 inch and flange nuts, 5/16 inch (Fig. 2 and 3).
3
1
Note: The 38 inch deck will use four bolts for the left gage
wheel bracket.
4. Lower the mower.
3
4
4
3
m–6672
4
2
Figure 2
38 inch deck shown
1. Right gage wheel 2. Left gage wheel 3. Bolt, 5/16 x 5/8 inch 4. Flange nut, 5/16 inch
3
3
2
m–6671
1
4
4
Figure 3
42 inch deck shown
1. Right gage wheel 2. Left gage wheel 3. Bolt, 5/16 x 5/8 inch 4. Flange nut, 5/16 inch
2