Toro 106-5491 Installation Instructions

Mid–Size Weight Kit
Proline Mid–Size Mowers
Installing the Mid–Size Weight Kit on 36 inch Mowers
1. Secure the weight to front of the carrier frame with 2
capscrews, washers and nuts (Fig. 1).
1
2 3
1. Weight mounted in front position
2. Capscrew
Figure 1
3. Washer
4. Nut
4
Form No. 3329–228
Installation Instructions
1
3
2
1. Weight mounted in rear position
2. Capscrew
Figure 2
3. Washer
4. Nut
4
Installing the Mid–Size Weight Kit on 52 inch Mowers
Note: The use of a Tru–Trak Sulky on a 36 inch mower is not recommended.
Installing the Mid–Size Weight Kit on 44 inch Mowers
1. Secure the weight to front of the carrier frame with 2
capscrews, washers and nuts when a Tru–Trak Sulky is installed (Fig. 1).
2. Securing the weight to rear of frame with 2 capscrews, washers and nuts is optional when a Tru–Trak Sulky is not installed (Fig. 2).
Note: Installing this weight kit on 44 inch mowers can improve performance on slopes without the Tru–Trak Sulky.
1. Secure weight to rear of frame with 2 capscrews,
washers and nuts (Fig. 2).
Note: The weight mounted in the rear position is recommended, except when a Tru–Trak Sulky is
installed. The weight mounted in the back position, must be removed when the when a Tru–Trak Sulky is installed.
Warning
With the weight installed in the rear position, the front end of the machine can rapidly raise up when the mower is removed. This could cause serious injury to you or bystanders.
Support the rear of the machine when removing
the mower from the carrier frame.
2003 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196
All Rights Reserved
1
Printed in the USA
Loading...