Toro 106-2245 Installation Instructions
Light Kit
TimeCutter Z Riding Mower
Part No. 106–2245
Installation Instructions
Note: This kit is for the TimeCutter Z Model 74350 only.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
Description Qty. Use
Light assembly 1 Installing the light assembly
Wire harness 1 Installing the wire harness
Fuse 1 Installing the fuse
Form No. 3329–506
Drilling Holes for the Wire
Harness
There are two holes to drill for installing the wire harness.
One is located in the front and the other on the right side of
the frame.
1. In the front of the machine, measure 7–1/2 inches
(19 cm) over from the right adjusting nut and up 1–1/4
inches up from the mower frame (Fig. 1).
Note: The hole will be centered between the two adjusting
nuts.
2. Mark the location and drill a 1/4 inch dia. hole in the
front of the machine (Fig. 1).
3. Remove any burrs from the drilled hole on both sides of
the frame (Fig. 1).
1
4
3
4. Locate the hole on the right side of the machine by
measuring 3 inches (76 mm) over and 1–1/2 inches
(38 mm) up as shown in Figure 3.
5. Mark the location and drill a 1/4 inch dia. hole in the
side of the machine (Fig. 1).
6. Remove any burrs from the drilled hole on both sides of
the frame (Fig. ).
2
1. 1/4 inch hole to drill
2. 3 inches (76 mm)
1
Figure 2
3. 1–1/4 inches (32 mm)
4. Right side of the machine
4
3
m–6660
2
Figure 1
1. 1/4 inch hole to drill
2. 7–1/2 inches (19 cm)
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
3. 1–1/4 inches (32 mm)
4. Right adjusting nut
m–6649
Installing the Light Assembly
1. Remove the two bolts, washers, and locknuts that are on
the front of the machine and farthest to the outside
(Fig. 3).
All Rights Reserved
Printed in the USA
1
2. Attach the light bracket to the front of the mower with
the bolts, washers, and nuts removed in step 1 (Fig. 3).
1
3
7
6
Installing the Wire Harness
1. Route the wire harness under the foot rest and above the
support rods (Fig. 5).
3
7
4
2. Connect the two head light connectors to the wire
harness (Fig. 3).
3. Install the wire harness clip into the hole in the front of
the machine (Fig. 5)
5
2
4
m–6654
Figure 3
1. Light assembly
2. Mower
3. Light connector
4. Bolt
5. Locknut
6. Washer
7. Wire harness
Installing the Switch
1. Remove the plug in the control panel.
2. Install the light switch into the control panel (Fig. 4).
1
6
4
5
1
2
3
1
m–6652
Figure 5
1. Wire harness
2. Support rods
3. Mower
4. Footrest
5. Harness clip
6. Hole drilled in front
4. Route the harness along the right side of the footrest
and under the height–of–cut lever (Fig. 6).
2
5. Install the wire harness clips into the holes in the side of
the frame (Figures 6 and 7).
Figure 4
1. Control panel 2. Light switch
m–6651
2
Loading...